Loading...
HomeMy WebLinkAboutSanford-Roll-On-Stamp-Pad-Inker MATERIAL SAFETY DATA SHEET MSDS # 58701 February 1, 2007 Page 1 of 2 Section One: Identification Sanford, L.P. 2707 Butterfield Road Oak Brook, IL 60523 USA 800-323-0749 or 630-481-2000 EMERGENCY MEDICAL NUMBER: 888-786-0972 Product Name: Sanford Roll-on Inker Colors: Black, Red, Blue Sanford is a member of The Art and Creative Materials Institute, Inc. This product is certified by the Institute to be labeled in accordance with the voluntary chronic hazard labeling standard ASTM D-4236 and is labeled with the AP Non Toxic Seal. Products bearing the AP Approved Product Seal of The Art and Creative Materials Institute, Inc. are certified in a program of toxicological evaluation by a medical expert, subject to review by the Institute Toxicology Advisory Board, to contain no materials in sufficient quantities to be toxic or injurious to humans, or to cause acute toxicity or chronic health problems. Section Two: Hazard Identification This product is considered safe under normal use conditions. Section Three: Composition Glycerine (56-81-5), water, resins, diethylene glycol (111-46-6), dyes Section Four: First Aid Measures Inhalation: This product is considered safe under normal use conditions. Skin Contact: This product is considered safe under normal use conditions. Eye Contact: This product is considered safe under normal use conditions. Ingestion: This product is considered safe under normal use conditions. Section Five: Fire Fighting Measures Flash Point: Not flammable Flammability Limits (% by volume): Lower: Not applicable Upper: Not applicable Extinguishing Media: As appropriate for surrounding area Special Fire Fighting Measures: None Unusual Fire and Explosion Hazards: None Section Six: Accidental Release Measures In Case of Spill or Accidental Release: Wipe up with absorbent material Section Seven: Handling and Storage Handling: Do not squeez bottle. Storage: Keep cap on bottle when not in use. Section Eight: Exposure Controls and Personal Protection Eye Protection: None under normal use conditions. Clothing: None under normal use conditions. Respirator: None under normal use conditions. Ventilation: None under normal use conditions. MATERIAL SAFETY DATA SHEET MSDS # 58701 February 1, 2007 Page 2 of 2 Section Nine: Physical and Chemical Properties For ink unless otherwise specified: Boiling Point: Not available Specific Gravity: Not determined Vapor Pressure: Not determined Solubility in Water: Soluble Evaporation Rate: Not determined Appearance/Odor: Colored liquid; slight odor Section Ten: Stability and Reactivity Stability: Stable Conditions to Avoid: None known Chemical Incompatibility: None known Hazardous Decomposition: None known Hazardous Polymerization: Will not occur Section Eleven: Toxicological Information See Section Two: Hazard Identification for any hazards Section Twelve: Ecological Information Not available Section Thirteen: Disposal Considerations Dispose in accordance with Federal, State, and Local Regulations. Section Fourteen: Transport Information DOT: Not regulated IATA: Not regulated IMO: Not regulated Section Fifteen: Regulatory Information TSCA: The product listed on this Material Safety Data Sheet is not listed on the Toxic Substances Control Act Inventory. All ingredients used to manufacture this product are listed on the TSCA Inventory Section Sixteen: Other Information HMIS Code Health 1 Flammability 0 Reactivity 0 Personal Protection N/A 0=Minimal / 4 = Severe Sanford has been advised by Counsel that the OSHA Hazard Communication Standard does not apply to the Sanford Product described in this Material Safety Data Sheet. The reason for the exemption is contained in 29 CFR 1910.1200(b)(6)(ix) as amended July 1, 2006 per the Code of Federal Regulations. The information contained in this MSDS is forwarded to you for your information, but is not meant to imply that the product is covered by the Hazard Communication Standard nor is this MSDS meant to comply with all requirements of the Hazard Communication Standard.